August Stephenson – Diamond

August Stephenson – Diamond – Early references:
Diamonds were traded to both the east and west of India and were recognized by various cultures for their gemological or industrial uses. In his work Naturalis Historia, the Roman writer Pliny the Elder noted diamond’s ornamental uses, as well as its usefulness to engravers because of its hardness. It is however highly doubtful that Pliny actually meant diamonds and it is assumed that in fact several different minerals such as corundum, spinel, or even a mixture with magnetite were all referred to by the word “adamas”.

Diamond in jewelry:

Perhaps the most famous use of the diamond in jewelry is in engagement rings, which became popular in the early to mid 20th century due to an advertising campaign by the De Beers company, though diamond rings have been used to symbolize engagements since at least the 15th century. August Stephenson

August Stephenson Light performance – brilliance, fire, and scintillation

In the gem trade, the term light performance is used to describe how well a polished diamond will return light to the viewer. There are three light properties which are described in relation to light performance: brilliance, fire, and scintillation. Brilliance refers to the white light reflections from the external and internal facet surfaces. Fire refers to the spectral colors which are produced as a result of the diamond dispersing the white light. Scintillation refers to the small flashes of light that are seen when the diamond, light source or the viewer is moved. A diamond that is cut and polished to produce a high level of these qualities is said to be high in light performance.

The poorly performing stone:
In addition to carrying the most importance to a diamond’s quality as a gemstone, the cut is also the most difficult to quantitatively judge. A number of factors, including proportion, polish, symmetry, and the relative angles of various facets, are determined by the quality of the cut and can affect the performance of a diamond. A diamond with facets cut only a few degrees out of alignment can result in a poorly performing stone. For a round brilliant cut, there is a balance between “brilliance” and “fire.” When a diamond is cut for too much “fire,” it looks like a cubic zirconia, which gives off much more “fire” than real diamond. A well-executed round brilliant cut should reflect light upwards and make the diamond appear white when viewed from the top. An inferior cut will produce a stone that appears dark at the center and in extreme cases the setting may be seen through the top of the diamond as shadows.

August Stephenson devotion, skills, and also expertise

INFRARED SPECTRA – A representation of the vibrational modes of a diamond’s or colored gemstone’s molecules over a range of wavelengths outside of the visible spectrum. They are recorded on a graph that plots intensity against wavelengths. And they can help identify the species and/or variety of stone.

SI Grades (Slightly Included)
(Slightly Included) describe diamonds with small inclusions that are easy or very easy to see, under the conditions described above. Occasionally, inclusions in the SI category are visible to the unaided eye.
I Grades (Included)
(Included) describe diamonds with medium or large inclusions that are usually obvious to the unaided eye, under standardized lighting conditions.

INTERNAL LASER DRILL – In a diamond, a flat channel-like feature created by a laser beam during the treatment of an included crystal. The internal laser drill extends from the inclusion to the stone’s surface, where it appears as a linear feature. See also Plotting Diagram.

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>